Proper mining conditions and how to extend your mining tire life

Maio 23, 2023

Proper mining conditions and how to extend tire life

With rigid haul truck tires being one of the highest expenses for your mining operations, maintaining proper mining conditions for the tires plays a key role in extending tire life. In this article, we discuss in depth factors that affect your mining tire’s life and some ways to improve site conditions, ensuring maximum tire life and productivity.

Inflation Pressure

Inflation pressure is dependent on:

  • Load / overload
  • Type of service
  • Tire type and location on the vehicle
  • Designed (percentage) deflection of the tire

Keep in mind that the published inflation pressures recommended by your manufacturer are for standard loads. If you overload, inflation pressure should be increased 2% for each 1% of overload and max out at 14% of 7% overload.

Below is a comparison of what overinflation and underinflation does for your mining tires.

Loads

Ensure that the shovel operator controls the specified payload and distributes the load equally on each tire of the equipment because all tires should carry equal loads. MAXAM always recommends operations refer to the pressure load table specific to each tire to determine tire load according to the size and ply, and star rating.

Overloading can cause:

  • Casing and heat fatigue
  • Radial cracking
  • Inner liner failure
  • Greater chance for impacts
  • Reduced rim life
Here’s an illustration of how overloading can affect tire life relatively.

Grades

Haul roads should be ideally straight for rigid dump trucks because for every 1% change in grade, the load will transfer 2%. Below is an example of the setting level for your front and rear tires on a 777D rigid dump truck and how it affects the tires.

LoadTire Life
Rated100%
110%90%
120%80%
140%50%
tire life vs. load

Tire life or cost to fix the grade should be decided by the mine. However, having the downtime might affect overall productivity.

Grades should be minimized for a degree of rise and length. Best grades usually range from 5% to 8%, which will reduce tire slip and increase overall fuel economy.

Underfoot conditions

Ensure the haul road is clean with minimum spillage with rocks by conducting continuous use of graders around the site.

Tires that are being run on a rutted road can have:

  • sidewall and tread cuts
  • stress on the casing when the truck enters and leaves the rut
ConditionTire life
Soft earth – no rock100%
Soft earth – some rock90%
Shot rock60%
Shot rock in water40%
A good haul road is equivalent to a lower cost per hour. Poor haul roads will lead to early tire failures due to:
  • rock cuts
  • chunking
  • rock cut separations

Curves

The less curves your mine site has, the better, more importantly, negative curves should never exist. Trucks running around curves can:

  • Put high lateral tire forces which significantly increases wear and tear
  • Inconsistent speeds
  • Increase chance of spillage
  • Slower cycle time


Curves


Tire life
None100%
Moderate90%
Severe80%

Maintaining proper mine site condition is a cross-departmental effort, involving mine management, engineering, operations, training, maintenance, purchasing, tire maintenance and tire manufacturers. With rigid haul trucks’ tires being one of the top expenses for mining operations, ensuring the utmost condition of the mine site will significantly increase tire life.

Should you need further assistance, contact your local MAXAM rep and we’ll assist you with your inquiries.

Centro de recursos

A MAXAM Tire é um líder global e fabricante de pneus especiais desenhados e construídos especificamente para si.

EcoPoint³’s effect on reducing heat buildup

Março 11, 2023 Technical Bulletin

When it comes to forklift tires, heat buildup is a key contributor to tire failure. The lower the heat buildup, the more durable a tire can be.

Ler mais

MAXAM on When a Producer Should Replace Their Agricultural Tires

Junho 20, 2022 Technical Bulletin

In the agricultural industry, it is how the equipment is utilized or the inherent operational requirements that will affect the tire replacement cycle. As agricultural tires are considered off-road and not US Department of Transportation (DOT) regulated, there are no firm rules to determine when an ag tire absolutely needs to be replaced....

Ler mais

When should you replace solid OTR tires?

Maio 16, 2023 Technical Bulletin

While solid OTR tires require zero maintenance and are built to last much longer than foam filled pneumatics, they still have a certain life span. Although these tires don’t require the maintenance pneumatic off-the-road tires require, MAXAM recommends operations inspect their solid OTR tires every now and then.

Ler mais

Junte-se à nossa rede

Subscreva a nossa newsletter para receber as últimas notícias, ofertas de produtos e conteúdos exclusivos diretamente na sua caixa de correio.